Epic adventurer Solar boat progress

I made some progress today buy building the frame to hold the solar panel on my little boat.

Not a lot of progress, but a bit.

I was prompted by Dave, a solar panel exporter from China to make some progress, so here is the result.

I made it all out of 25mm aluminium pipe, and plastic plumbing fittings. It should work well enough once I tie or wire it down. I might add some wire tension as well to make sure it all stays where it should.

The best part of my new adult construction kit is that Im able to adjust any of it on the go with nothing more than my hands and some luck.

At some point I plan on building a solar tracker so my panel always points to the sun regardless of where my little boat is pointing.

As a result, I?ll need the design to be flexible enough to allow me to add electronics and some kind of actuators to raise and lower different ends, and sides of the panel.

The basic plan will see me sit at the end with the chair on the right, looking under the solar panel when Im sitting, and looking over the top of the panel when standing. This height gives an unrestricted view when sitting or standing.

When sitting, I wont cast a shadow on the panels even when the sun is setting directly behind me.

The panel will sit on top of the two bars and form the final bit of structure.

That should work.

Related Posts by Categories